Cables Archives | Page 2 of 2

Hudson Servo Motor Encoder Cable – IP66K/IP67, 55 ft

Wednesday, December 20th, 2023

This is a cable to connect the phase signals of a Hudson brushless servo motor (with the M12 connector option) to any compatible servo drive. This cable can be cut to make two cables with a Hudson motor connector on one end and flying leads on the other.

Posted in | Comments Off on Hudson Servo Motor Encoder Cable – IP66K/IP67, 55 ft

Hudson Servo Motor Extension Cable

Monday, December 21st, 2020

Cable connects your Hudson brushless servo motor optioned with the Molex pigtail to your servo drive. This cable can be cut to make two cables with a Molex motor connector on one end and flying leads on the other. Note: When testing a motor with a third party drive, Teknic expects you to modify this cable. Do not modify the motor pigtail itself as motor modification voids the motor warranty. For development purposes, Teknic will warrant up to 9 modified motor cables.

Posted in | Comments Off on Hudson Servo Motor Extension Cable

Hudson Servo Motor Phase Cable – IP66K/IP67, 10 ft

Wednesday, December 20th, 2023

This is a cable to connect the phase signals of a Hudson brushless servo motor (with the M12 connector option) to any compatible servo drive.

This cable has a mating 4-pin Molex Sabre connector on the drive end (instead of “”flying leads””) to allow us to electrically test every cable before it ships. Most customers will cut off this connector to wire the cable to their specific motor drive connector(s).

Posted in | Comments Off on Hudson Servo Motor Phase Cable – IP66K/IP67, 10 ft

Hudson Servo Motor Phase Cable – IP66K/IP67, 55 ft

Wednesday, December 20th, 2023

This is a cable to connect the encoder signals of a Hudson brushless servo motor (with the M12 connector option) to any compatible servo drive. This cable can be cut to make two cables with a Hudson motor connector on one end and flying leads on the other.

Posted in | Comments Off on Hudson Servo Motor Phase Cable – IP66K/IP67, 55 ft

I/O Cable, 4-Pin Molex

Wednesday, August 10th, 2016

Cable used to connect an analog input to an ASU-FR510 Analog Send Unit (analog to digital converter). This cable uses 22 AWG wire and so is not suitable for use as a DC power cable for a ClearPath motor.

Posted in | Comments Off on I/O Cable, 4-Pin Molex

USB Cable for Serial Communications

Tuesday, October 17th, 2023

USB cable used to connect the Infrared (IR) Converter board (USB type-C port) to a Windows PC (USB type-A port).

You only need one USB cable for each Infrared (IR) converter board, regardless of your ClearPath quantity.

Posted in | Comments Off on USB Cable for Serial Communications

USB Cable, for ClearPath Rear USB Port

Wednesday, March 20th, 2013

Cable used to connect a fractional hp (DC input) ClearPath-MC or -SD motor to a Windows PC in order to configure the motor using the ClearPath MSP software. Once configured, the motor is disconnected from the PC, so you only need one of these cables no matter how many ClearPath motors you buy. (This cable can also be used to connect to the rear diagnostic port of a ClearPath-SC motor.)

Posted in | Comments Off on USB Cable, for ClearPath Rear USB Port

USB Cable, for SC4-HUB to USB Port

Wednesday, August 10th, 2016

Cable used to connect your host PC to a ClearPath-SC communication hub (e.g., SC4-HUB). Note: this cable cannot be used with ClearPath-MC or -SD series models; for those, use CPM-CABLE-USB-120 (which has a micro-B connector).

Posted in | Comments Off on USB Cable, for SC4-HUB to USB Port